#Cisco 5505 asa cli does not work how to#
The following example shows how to specify the ASA 5505 as an Easy VPN hardware client: hostname(config)# vpnclient enable hostname(config)# no vpnclient enable to specify the role of the ASA 5505 as server.vpnclient enable to specify the role of the ASA 5505 as an Easy VPN Remote.Use one of the following commands in global configuration mode to specify its role: The Cisco ASA 5505 can function as a Cisco Easy VPN hardware client (also called “Easy VPN Remote”) or as a server (also called a “headend”), but not both at the same time. Specifying the Client/Server Role of the Cisco ASA 5505 Guidelines for Configuring the Easy VPN Server.Specifying the Tunnel Group or Trustpoint.
Configuring Automatic Xauth Authentication.Specifying the Primary and Secondary Servers.Specifying the Client/Server Role of the Cisco ASA 5505.This chapter includes the following sections: Then configure the ASA 5505 as you would any other ASA, beginning with the "Getting Started" in the general operations configuration guide. To configure an ASA 5505 as a server, see the Specifying the Client/Server Role of the Cisco ASA 5505. An ASA 5505 cannot, however function as both a client and a server simultaneously. Any ASA, including another ASA 5505 configured as a headend, a VPN 3000 Series Concentrator, an IOS-based router, or a firewall can act as an Easy VPN server. Note The Easy VPN hardware client configuration specifies the IP address of its primary and secondary (backup) Easy VPN servers. This chapter assumes you have configured the switch ports and VLAN interfaces of the ASA 5505 (see "Starting Interface Configuration" in the general operations configuration guide). This chapter describes how to configure the ASA 5505 as an Easy VPN hardware client.